Mabuchi # PF35T-48L4. Four phase, unipolar stepper motor with 6 leads. 3.6 Degree step angle. 20 Ohms. 7V, 350mA. 1.38" diameter x 0.59" long. Mounting flange has two holes on 1.68" centers. Dual shaft, 0.078" diameter. Brass gear on one side, 10 teeth, 0.25" diameter. 2.75" leads with socket connector.
Customer Comments
A customer from DFW
specs
This is a 7.5degree / 48 step motor. Mine gets a bit warm at 7v but seems ok at 6v. I wired it bipolar using a sn754410. Wire colors to the sn754410 numbers are: 1 brown, 2 black, 3 yellow, 4 orange. Green is the middle for brown-black, red is the middle for yellow-orange.
A customer from Chicago, IL
Connection Diagram
While searching for resources regarding this motor, I ran across a PNG graphic illustrating the motor's connection to a ULN2803a darlington array driver. The link below is referenced from owenmundy.com Thanks Owen!! http://bit.ly/eStZM2
A customer from Florida
Outstanding little motor!
Further clarification-The gear is a 10 tooth, 48 pitch , and is a press fit. This motor has excellent torque for its size,is easy to mount and interface with. I hope they have bunches of these in stock.......
A customer from San Francisco Bay Area
This is a 48 step Nippon Electric Pulse Motor
I have successfully used this motor in a turntable design. It runs nicely at 12V and consumes around 200 ma per phase. The motor can be run in either unipolar or bipolar mode.
Add to Wishlist
Tell a Friend
Customer Service: